No Network Services After Install Over LAN Manager 2.0

 Last reviewed: November 21, 1994
Article ID: Q90982
The information in this article applies to:
  • Microsoft Windows for Workgroups versions 3.1, 3.11

SYMPTOMS

After you install Windows for Workgroups over Microsoft LAN Manager version 2.0, the network services do not start because Setup did not add a NET START command to AUTOEXEC.BAT.

RESOLUTION

LAN Manager version 2.0 is not a supported network for Windows for Workgroups. You can perform a successful upgrade by removing the references to the LAN Manager network from AUTOEXEC.BAT before running Windows for Workgroups Setup.

KBCategory: kbnetwork kbsetup kbinterop kbprb kbenv
KBSubcategory: wfw wfwg
Additional reference words: 3.10 3.11

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 21, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.