Problems Running Autocad 386 Version 12 in Privileged Mode

Last reviewed: November 23, 1994
Article ID: Q93264

The information in this article applies to:

Microsoft Windows operating system versions 3.1, 3.11

SUMMARY

AutoCAD technical support has confirmed that AutoCAD 386 version 12 may have problems running in privileged mode under Windows 3.1.

MORE INFORMATION

To check to see if the customer is in privileged mode, type the following at the ACAD directory and press ENTER:

   Cfig386 Acad

There should be a set of variables on the screen.

If you see the variable privileged, then the AutoCAD mode has been changed to privileged. You must be in unprivileged mode to run in the Windows environment.

To Change from Privilege to Unprivileged Mode

From within the ACAD directory:

Type the following and press ENTER:
```
      Cfig386 Acad -Clear
```

Type the following and press ENTER:

      Cfig386 Acad -MINSWFSIZE 400000 -SWAPDEFDISK -SWAPCHK OFF
      -DEMANDLOAD VSCAN 20000 -UNPRIV

This resets AutoCAD to its default settings as well as sets the mode to unprivileged.

For more information, contact Autodesk.

KBCategory: kb3rdparty
KBSubcategory: win31
Additional reference words: 3.10

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 23, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.