Using the Intel EtherExpress 16 MCA with WFWG 3.1

Last reviewed: November 21, 1994
Article ID: Q95120
The information in this article applies to:
  • Microsoft Windows for Workgroups version 3.1

The following article contains information on the use of Windows for Workgroups with third-party products or configurations that have not been tested and are not supported by Microsoft.

If the steps or procedures described in this article do not function properly, contact the manufacturer of the third-party product for more information or use a supported configuration.

SUMMARY

The Intel EtherExpress 16 MCA is not directly supported or specifically listed in the Network Adapter options in Windows for Workgroups version 3.1. However, this network adapter should operate with Windows for Workgroups if it is set up correctly.

NOTE: The Intel EtherExpress MCA IS supported in later versions of Windows for Workgroups.

The Intel EtherExpress 16 MCA is the Microchannel version of the Intel EtherExpress 16 or 16 TP that Microsoft ships with the Windows for Workgroups Starter Kits and User Kits. Both network adapters use the same Media Access Control (MAC) driver. The Microchannel version of the Intel EtherExpress 16 should not require any changes to the PROTOCOL.INI or any other configuration files in order to operate with Windows for Workgroups.

MORE INFORMATION

To install and configure the EtherExpress MCA LAN Adapter for use with Windows for Workgroups version 3.1, use the following steps:

  1. Install and set up the Intel EtherExpress MCA using the reference disk provided with the adapter.

  2. Make note of the configuration, such as the IRQ, I/O Port address, and Base Memory settings.

  3. During the installation of Windows for Workgroups, select the Intel EtherExpress 16 or 16 TP when prompted for the network adapter card information.

  4. The IRQ, I/O Port, and Base Memory settings must match those that were set up using the reference disk.

    NOTE: If the card settings are changed at any time in the future, make sure those same changes are made in the Control Panel Network Adapters Settings section. Conversely, if IRQ, I/O or Base Memory settings are ever changed with the Control Panel or in the PROTOCOL.INI file, be sure to use the reference diskette and make the corresponding changes.

For additional information, contact Intel technical support.

The EtherExpress 16 MCA is manufactured by Intel, a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this products' performance or reliability.


KBCategory: kbnetwork kb3rdparty kbhw
KBSubcategory: wfw wfwg
Additional reference words: 3.10 netcard nic 3rdparty


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 21, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.