After Running ATI Mach32 Setup, System Uses Safe Mode Startup

Last reviewed: September 13, 1995
Article ID: Q123249

The information in this article applies to:

Microsoft Windows 95

SYMPTOMS

After you run the ATI Mach32 setup utility (INSTALL.EXE), you may be unable to start the computer except in Safe Mode.

CAUSE

This problem occurs because the Windows 3.x drivers supplied by ATI conflict with the Windows 95 drivers.

RESOLUTION

ATI has updated versions of the drivers available on its BBS. The updated drivers work only if you have previously installed an ATI Windows 3.1 driver. For more information about the updated versions of the video drivers, contact ATI.

KBCategory: kb3rdparty kbsetup kbhw kbdisplay
KBSubcategory: wpp95 win95 winboot
Additional reference words: 95 3rdparty mach32

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 13, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.