Error Message: The Fax Server Could Not Be Removed

Last reviewed: September 14, 1995
Article ID: Q136741

The information in this article applies to:

Microsoft Windows 95

SYMPTOMS

If you remove a fax device (local or network) from the list of available fax/modems on the Modem tab in the properties for Microsoft Fax, the fax device may not be removed from the list. If you try to remove the fax device again, you may receive the following error message:

   The fax server could not be removed

CAUSE

The registry settings are changed, but the display was not updated properly.

RESOLUTION

Close the properties for Microsoft Fax and then open the properties again to refresh the list of available fax devices.

KBCategory: kbatwork kbprb kberrmsg
KBSubcategory: win95 awfax
Additional reference words: 95

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 14, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.