XCOPY /F Command Does Not Display Destination Path

 Last reviewed: September 30, 1996
Article ID: Q153601
The information in this article applies to:
  • Microsoft Windows 95
  • Microsoft Windows 95 OEM Service Release 2

SYMPTOMS

When you use the XCOPY command with the /F switch to copy files or folders from one location to another, the destination file and folder names are not displayed.

If you type "xcopy /?" you see the following Help topic for the /F switch: 

   Displays full source and destination file names while copying.

STATUS

Microsoft is researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.

KBCategory: kbtool
KBSubcategory: win95
Additional reference words: 95 osr2

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 30, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.