Error Message: Invalid Product Identification Number

Last reviewed: October 2, 1996
Article ID: Q156825
The information in this article applies to:
  • Microsoft Windows 95

SYMPTOMS

When you are using an .inf file to perform a batch installation of Windows 95, you may receive the following error message during Setup:

   Invalid Product Identification Number

When you click Ignore, Setup continues normally.

CAUSE

This error can occur if the .inf file contains the "Display=1" setting.

RESOLUTION

Change the "Display=1" setting to "Display=0" in the [NameAndOrg] section of the .inf file. Note that the occurrence of this problem is dependent upon many variables; the problem is not always reproducible.

STATUS

Microsoft is researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.


KBCategory: kbsetup kberrmsg
KBSubcategory: win95
Additional reference words: 95 msbatch


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 2, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.