Dialing Out Using 32-Bit Program Returns Busy Signal

Last reviewed: December 9, 1996
Article ID: Q160625
The information in this article applies to:
  • Microsoft Windows 95

SYMPTOMS

When you try to dial out using a 32-bit program, you may receive a busy signal and the following message:

   The line is busy
   Try again later.

CAUSE

This behavior can occur if your modem is configured to disable Call Waiting when the Call Waiting service is not active on your phone service.

When Call Waiting is enabled, a prefix is automatically dialed when a 32-bit program dials out. With Call Waiting no longer available, dialing the prefix returns a busy signal.

RESOLUTION

To remove the dialing prefix, follow these steps:

  1. In Control Panel, double-click Modems.

  2. Click the modem you are using, and then click Dialing Properties.

  3. On the My Locations tab, click the "This location has call waiting. To disable it, dial" check box to clear it.

  4. Click OK.


KBCategory: kbenv
KBSubcategory: win95 wincomm
Additional reference words: 95


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: December 9, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.