Multiple Tape Set with Iomega 250 Tape Backup in NT

Last reviewed: May 9, 1997
Article ID: Q103842

The information in this article applies to:

Microsoft Windows NT operating system, version 3.1
Microsoft Windows NT Advanced Server, version 3.1

SYMPTOMS

In Microsoft Windows NT or Windows NT Advanced Server, if Verify After Backup is enabled when you perform a backup of a hard drive that requires more than one tape, it repetitively asks for Tape 1.

STATUS

Iomega Corporation have confirmed this to be a problem with Iomega 250 Tape in Windows NT version 3.1. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.

REFERENCES

Iomega Corporation technical support (800) 456-5522

                             BBS     (801) 392-9819
                             FaxBack (801) 778-5763

Additional query words: prodnt
Keywords : kbhw nthw
Version : 3.1
Platform : WINDOWS

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: May 9, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.