Extended Characters with AT Command May Display Incorrectly

Last reviewed: May 9, 1997
Article ID: Q104019

The information in this article applies to:
  • Microsoft Windows NT operating system version 3.1
  • Microsoft Windows NT Advanced Server version 3.1

SYMPTOMS

If you use AT to specify a command with extended characters, the extended characters may not be displayed properly in the command list generated by the AT command.

Steps to Reproduce Problem

  1. Start the Schedule service with Control Panel, Services.

  2. Open a command prompt (CMD.EXE) from the Main group and enter the following command

          AT 12:00 NET SEND TEST <extchar>
    

    where <extchar> is an extended character.

  3. Type AT and press ENTER to display the AT command list.

The <extchar> will not display properly in the AT command list.

STATUS

Microsoft has confirmed this to be a problem in Windows NT version 3.1 and Windows NT Advanced Server version 3.1. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.


Additional query words: prodnt
Keywords : kbbug3.10 kbtool ntutil
Version : 3.1
Platform : WINDOWS


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: May 9, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.