TCP/IP Name Resolution

Last reviewed: November 12, 1997
Article ID: Q108295
The information in this article applies to:
  • Microsoft Windows NT operating system version 3.1
  • Microsoft Windows NT Advanced Server version 3.1

SUMMARY

TCP\IP under Windows NT allows a computer to communicate over a network with another computer by using either an IP address, a host name, or a NetBIOS name. However, when one computer attempts to communicate with another computer using one of these three naming conventions, that name must ultimately be resolved to a hardware address. The following are the steps used by TCP\IP to resolve a host name and a NetBIOS name to a hardware address.

MORE INFORMATION

Host Name Resolution Using a Hosts File

  1. Computer A enters a command using the host name of Computer B.

  2. The HOSTS file on Computer A (contained in the %SystemRoot%\system32\drivers\etc directory ) is parsed. When the host name of Computer B is found, it is resolved to an IP address.

  3. The Address Resolution Protocol (ARP) is then used to resolve the IP address of Computer B to its hardware address. If Computer B is on the local network, its hardware address will be obtained by using the ARP cache or by sending a local broadcast asking for a reply from Computer B with its hardware address. If Computer B is on a remote network, ARP will determine the hardware address of the default gateway for routing to Computer B.

NOTE: Host name resolution using a Domain Name Server (DNS) is similar to the steps outlined above. Instead of parsing the HOSTS file in Step 2, the DNS looks up the host name of Computer B in its database and resolves it to an IP address.

NetBIOS Name Resolution

  1. Computer A enters a Windows NT command using the NetBIOS name of Computer B.

  2. The NetBIOS name cache on Computer A is checked for the IP address that corresponds to the NetBIOS name of Computer B.

  3. If the IP address of Computer B is found in the NetBIOS name cache, ARP will resolve the IP address to Computer B’s hardware address (see Step 3 of the Host Name Resolution Using A Hosts File section above). If, however, the NetBIOS name is not resolved from the NetBIOS name cache, Computer A broadcasts a name request with the NetBIOS address of Computer B.

  4. If Computer B is on the local network, Computer A will receive a response to its name request broadcast containing the IP address of Computer B. ARP will then resolve Computer B’s IP address to its hardware address.

  5. If Computer B is on a remote network, Computer A will not receive a reply to its name request broadcast. The LMHOSTS file on Computer A (contained in the %SystemRoot%\system32\drivers\etc directory) is then parsed. If a mapping for the NetBIOS name of Computer B exists, it is resolved to its IP address. Since this is the IP address of a remote computer, ARP will determine the hardware address of the default gateway for routing to Computer B.


Additional query words: prodnt
Keywords : NTSrvWkst nttcp kbnetwork
Version : 3.1
Platform : WINDOWS


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 12, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.