Dial-Up Networking Hangs After Failed Multilink Attempt

Last reviewed: September 30, 1997
Article ID: Q112547

The information in this article applies to:

Microsoft Windows NT Workstation version 4.0
Microsoft Windows NT Server version 4.0

SYMPTOMS

When you attempt to make a multilink Remote Access Service (RAS) connection that fails, the Dial-Up Networking dialog box may stop responding (hang) or freeze.

RESOLUTION

Obtain the fix mentioned below.

STATUS

Microsoft has confirmed this to be a problem in Windows NT version 4.0. A supported fix is now available, but has not been fully regression tested and should be applied only to systems experiencing this specific problem. Unless you are severely impacted by this specific problem, Microsoft recommends that you wait for the next Service Pack that contains this fix. Contact Microsoft Technical Support for more information.

Additional query words: prodnt
Keywords : kbbug4.00 kbfix4.00 NTRAS NTSrvWkst kbnetwork
Version : WinNT:4.0
Platform : winnt
Issue type : kbbug
Solution Type : kbfix

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 30, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.