STOP Message on MIPS Computer Caused by NET Command

 Last reviewed: May 14, 1997
Article ID: Q112637

The information in this article applies to:
  • Microsoft Windows NT Workstation version 3.5
  • Microsoft Windows NT Server version 3.5

SYMPTOMS

A MIPS-based computer running Windows NT may halt with a STOP message if you connect to it from another Windows NT computer (non-MIPS) and use the NET command. The STOP message is 0x0000001E.

STATUS

Microsoft has confirmed this to be a problem in Windows NT Workstation and Windows NT Server version 3.5. This problem was corrected in the latest U.S. Service Pack for Windows NT version 3.5. For information on obtaining the Service Pack, query on the following word in the Microsoft Knowledge Base (without the spaces): 

   S E R V P A C K

Additional query words: prodnt
Keywords : kbbug3.50 kbnetwork ntstop
Version : 3.5
Platform : WINDOWS
Issue type : kberrmsg

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: May 14, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.