DLC Printing Devices Control Settings Must be the Same

 Last reviewed: May 15, 1997
Article ID: Q114619
The information in this article applies to:
  • Microsoft Windows NT operating system version 3.1
  • Microsoft Windows NT Advanced Server version 3.1

If your Windows NT or Windows NT Advanced Server print server uses Data Link Control (DLC)-controlled printing devices, they must all have either continuous connections or job-based connections; you cannot have some connections of each type.

DLC printing does not allow you to configure some Hewlett-Packard (HP) network printing ports as job-based and others as continuous. All ports need to have the same type of connection.

The HP products discussed here are manufactured by Hewlett-Packard Co., a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.

Additional query words: prodnt
Keywords : kbbug3.10 kbnetwork kbprint ntprint ntprotocol NTSrvWkst
Version : 3.1
Platform : WINDOWS

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: May 15, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.