Cannot Insert Paintbrush OLE Object into SQLWindows on RISC

 Last reviewed: September 26, 1994
Article ID: Q120440
The information in this article applies to:
  • Microsoft Windows NT workstation version 3.5
  • Microsoft Windows NT Server version 3.5

SYMPTOMS

You cannot insert a Paintbrush OLE object into SQLWindows.

CAUSE

The KRNL286.EXE that is run on non-80x86 architectures (primarily RISC) cannot handle OLE objects that require more than 1 MB of memory.

RESOLUTION

Reduce the size of the Paintbrush object before inserting it, until the memory requirement for it is less than 1 MB. KRNL286.EXE can then handle it.

Additional reference words: prodnt 3.50
KBCategory: kb3rdparty
KBSubCategory: nt16ap

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 26, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.