Fatal Error on Drive 1 with Adaptec 1540CF SCSI ControllerLast reviewed: September 4, 1997Article ID: Q121520 |
The information in this article applies to:
SYMPTOMSWhen you use the Windows NT Backup program (NTBACKUP.EXE) with an Adaptec 1540CF SCSI controller and an Exabyte 8500 tape drive, the following error message may appear:
Fatal error on drive 1 CAUSEThis problem occurs when the on-board termination on the Adaptec 1540CF SCSI controller is not properly disabled.
RESOLUTIONThe Adaptec 1540CF SCSI controller has a software option for on-board termination instead of physical resistor terminators. To perform the error- free backup, the on-board termination on this SCSI card needs to be fully disabled with the software option. For additional information regarding the software option, call Adaptec Technical Support at (800) 959-7274. The products discussed here are manufactured by Adaptec, Inc., a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.
|
Additional reference words: prodnt 3.10 aha
© 1998 Microsoft Corporation. All rights reserved. Terms of Use. |