Err Msg: Error 692: Hardware Failure in Port or Attached....

 Last reviewed: August 19, 1997
Article ID: Q122839

The information in this article applies to:
  • Microsoft Windows NT operating system version 3.1
  • Microsoft Windows NT Advanced Server version 3.1
  • Microsoft Windows NT Workstation versions 3.5, 3.51 and 4.0
  • Microsoft Windows NT Server versions 3.5, 3.51 and 4.0

SYMPTOMS

When you dial a Remote Access Services (RAS) server in Windows NT, you may receive the following error message as the modem starts to initialize: 

   Error 692: Hardware failure in port or attached device.

CAUSE

This behavior can occur if any of the following conditions exists:

  • The modem is turned off or malfunctioning.
  • If you have an external modem, the serial cable is incorrect.
  • If you have an external modem, the serial cable is loose.
  • You are using a 9-to-25 pin adapter or a 25-to-9 pin adapter for the serial connection that is not wired correctly.
  • The serial port or multi-port adapter on the RAS server or client is malfunctioning.
  • The handshaking options for the modem need to be adjusted.
  • The modem is unsupported, or the chosen emulation may be incorrect.

RESOLUTION

To resolve this problem, use the appropriate method:

  • Reset your modem. Consult your hardware documentation for information about how to reset your modem.
  • If you have an external modem, ensure that you are using the proper serial cable. For more information about requirements for proper cabling, refer to the "Cabling Requirements" section in Dial-Up Networking Help.
  • If you have an external modem, ensure that the serial cable is connected securely.
  • If you are using a pin adapter to connect your external modem to your serial port, ensure that the pin adapter is wired properly for modem communication. For example, a 9-to-25 pin adapter for a mouse does not work properly with a RAS serial setup.
  • Test and replace the serial port or multi-port adapter, if necessary.
  • Ensure that the handshaking options for the modem are configured properly. Consult your hardware documentation for information about different handshaking options available for your modem.
  • Contact your modem manufacturer to see if they provide an .Inf file for your modem for your version of Windows NT. Also, check the latest Windows NT Hardware Compatibility list (HCL) to ensure that your modem is supported. For information about the Windows NT 4.0 HCL, see the following article in the Microsoft Knowledge Base: 

          ARTICLE-ID: Q131303

          TITLE     : Latest Windows NT Hardware Compatibility List (HCL)

    

	    
	

	















	






Additional query words: prodnt 3.10 3.51 3.50 4.00

Keywords          : ntconfig NTRAS NTSrvWkst kb3rdparty kbfasttip

Version           : 3.1 3.5 3.51 4.0

Platform          : winnt

Issue type        : kberrmsg








THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.






	
	Last reviewed:  August 19, 1997
	

	© 1998 Microsoft Corporation. All rights reserved. Terms of Use.