Multiple ISDN Adapters Cannot Be Installed

 Last reviewed: August 22, 1996
Article ID: Q123478
The information in this article applies to:
  • Microsoft Windows NT Workstation version 3.5
  • Microsoft Windows NT Server version 3.5

SYMPTOMS

When you configure a Windows NT Server with two PCIMAC adapters for Remote Access Service (RAS) dial-in, clients accessing both adapters when dialing the number will report that one of the cards doesn't respond, while one adapter does.

CAUSE

The driver setup was not configurable during Windows NT setup using the Network Control Panel for multiple adapters.

RESOLUTION

DIGIINSTL.DLL and PCIMAC.SYS have been updated to address configuration of multiple adapters.

STATUS

Microsoft has confirmed this to be a problem in Windows NT Workstation and Windows NT Server version 3.5. This problem was corrected in the latest U.S. Service Pack for Windows NT version 3.5. For information on obtaining the Service Pack, query on the following word in the Microsoft Knowledge Base (without the spaces): 

   S E R V P A C K

KBCategory: kbnetwork kbbug3.50 kbfix3.50.sp2
KBSubcategory: ntras NTSrvWkst
Additional reference words: prodnt 3.50 debugging

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: August 22, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.