Windows NT 3.5 Does Not Support TI MicroLaser Pro 600 Printer

Last reviewed: June 23, 1995
Article ID: Q123818
The information in this article applies to:
  • Microsoft Windows NT Workstation version 3.5
  • Microsoft Windows NT Server version 3.5

SUMMARY

Windows NT does not provide a printer driver for a TI MicroLaser Pro 600 printer. This printer is not supported by Windows NT at this time.

SYMPTOMS

When you print on a TI MicroLaser Pro 600 printer using the TI MicroLaser 600 printer driver, the first two lines print correctly, but the remainder of the print job is unreadable.

WORKAROUND

To work around this problem, use the Apple LaserWriter II series printer driver. For additional information, contact Texas Instruments Technical Support at (800) 848-3927.

The MicroLaser Pro 600 printer discussed here is manufactured by Texas Instruments, a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.


Additional reference words: prodnt 3.50 print
KBCategory: kbprint kb3rdparty
KBSubcategory: nthw


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: June 23, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.