Windows NT Setup Err Msg on NEC Express/II: STOP 0x0000000E

 Last reviewed: June 6, 1995
Article ID: Q126462
The information in this article applies to:
  • Microsoft Windows NT Workstation version 3.5
  • Microsoft Windows NT Server version 3.5

SYMPTOMS

When you attempt to install Windows NT version 3.5 on an NEC Express/II 433 ST or 466 ST, the following error message appears: 

   TRAP 0x0000000E Page Fault at linear address xxxxxxxx
This screen appears after you boot your computer from the Windows NT Setup Boot Disk.

CAUSE

There is a problem in the L2 cache implementation on the NEC Express/II 433 ST and 466 ST machines. These machines will be removed from future versions of the Windows NT Hardware Compatibility List (HCL).

STATUS

Microsoft has confirmed this to be a problem in Windows NT version 3.5. This problem was corrected in Windows NT version 3.51.

KBCategory: kbsetup kbhw kb3rdparty kbbug3.50 kbfix3.51
KBSubcategory: ntsetup ntstop
Additional reference words: 3.50 STOP 0xE 0000000E prodnt blue screen

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: June 6, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.