Improper Form Feed with Diconix 150 Plus Printer

 Last reviewed: March 21, 1997
Article ID: Q136843

The information in this article applies to:
  • Microsoft Windows NT Workstation version 3.5 and 3.51
  • Microsoft Windows NT Server version 3.5 and 3.51

SYMPTOMS

When you define 4 inch high custom form and then print to a Diconix 150 Plus driver from any application using that form, the printer uses a form feed at the end of the document as if you had used an 8.5 x 11 inch form.

STATUS

Microsoft has confirmed this to be a problem in Windows NT version 3.51. A supported fix is now available, but is not fully regression-tested and should be applied only to systems experiencing this specific problem. Unless you are severely impacted by this specific problem, Microsoft recommends that you wait for the service pack release containing this fix. Contact Microsoft Product Support Services for more information.

Additional query words: prodnt kodak inches 8.5" 11" 8.5x11 4"
four
Keywords : kbbug3.51 kbprint ntprint NTSrvWkst
Version : 3.5 3.51
Platform : WinNT

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: March 21, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.