COM Port failures with Digiboard mc/XEM

Last reviewed: September 15, 1995
Article ID: Q136858
The information in this article applies to:
  • Microsoft Windows NT Workstation version 3.51
  • Microsoft Windows NT Server version 3.51

SYMPTOMS

When you use a Digiboard XEM/mc multiport serial board for dial in access to a network on an NCR 3430 running with Windows NT Server RAS Server, some ports drop the RTS line and fail to respond to incoming dial-up connections after approximately 3000 connections.

CAUSE

The cause of this problem is currently under investigation. It seems to be configuration specific to the NCR 3430 Microchannel architecture and the Digiboard mc/XEM board.

WORKAROUND

To work around this problem, stop and restart the RAS service to reset the ports. You will need to do this every 3000 connections.

STATUS

Microsoft has confirmed this to be a problem Windows NT version 3.51. We are researching this problem and will post new information in the Microsoft Knowledge Base as it becomes available.

The third-party product discussed here is manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.


KBCategory: kbnetwork
KBSubcategory: ntdriver ntras
Additional reference words: prodnt 3.51


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 15, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.