Installing SCSI2GO PCMCIA Card in a Compaq Elite Laptop

Last reviewed: November 9, 1995
Article ID: Q139413

The information in this article applies to:

- Microsoft Windows NT Workstation version 3.51

SYMPTOM

After you install a Future Domain SCSI2GO PCMCIA Card in a Compaq Elite Laptop the following error message appears after you reboot the computer:

   Event ID 7026:  The following boot start or system start driver or
   drivers failed  Fd16_700.

WORKAROUND

To work around this problem, change the Device bootup properties in Control Panel Devices from Boot to System.

KBCategory: kb3rdparty
KBSubcategory: ntsetup
Additional reference words: 3.50 3.51 prodnt

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 9, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.