IBM Token Ring 16/4 Network Adapter II Switch SettingsLast reviewed: February 14, 1996Article ID: Q142912 |
The information in this article applies to:
SUMMARYThe following lists switch settings for the IBM Token Ring 16/4 Adapter II ISA network adapter: ROM ADDRESS (SW1-SW3):
SW1 SW2 SW3 RPL ROM ADDRESS I/O BASE ADDRESS --- --- --- --------------- ---------------- ON ON ON C0000 86A0 OFF ON ON C4000 96A0 ON OFF ON C8000 A6A0 OFF OFF ON CC000 B6A0 ON ON OFF D0000 C6A0 OFF ON OFF D4000 D6A0 ON OFF OFF D8000 E6A0 OFF OFF OFF DC000 F6A0INTERRUPT LEVEL (SW4-SW5):
SW4 SW5 Interrupt Requests (IRQ) --- --- ------------------------ ON ON IRQ 9 OFF ON IRQ 10 ON OFF IRQ 11 OFF OFF IRQ 15WAIT STATE (SW6): SW6 State --- ----- ON Normal OFF Fast ADAPTER MODE (SW7): SW7 Mode --- ---- ON Normal OFF Reserved RPL (SW8): SW8 Enable/Disable --- -------------- ON RPL DISABLE OFF RPL ENABLE DMA CHANNEL (SW9-SW10):
SW9 SW10 Channel --- ---- ------- ON ON 5 OFF ON 6 ON OFF 7 OFF OFF Not UsedRING SPEED (SW11): SW11 Speed ---- ----- ON 4 Mbps OFF 16 Mbps CABLE TYPE (SW12): SW12 Type ---- ---- ON STP OFF UTP For additional information on the IBM Token Ring 16/4 Adapter II network adapter, refer to the Installation and Test Instructions guide provided with the network adapter.
|
KBCategory: kb3rdparty kbhw
© 1998 Microsoft Corporation. All rights reserved. Terms of Use. |