Stop 0x4,0x1,0,0 on DEC ALPHA 1000 During Setup

Last reviewed: October 22, 1997
Article ID: Q156801

The information in this article applies to:

Microsoft Windows NT Workstation versions 3.51 and 4.0
Microsoft Windows NT Server versions 3.51 and 4.0

SYMPTOMS

You may receive the following STOP BLUE screen error message when Windows NT has been installed on a DEC Alpha 1000 computer and after its initial restart:

   STOP 0x4,0x1,0,0.

This usually occurs after the memory count is displayed and the HAL is loaded.

CAUSE

This problem can be the result of the CD-ROM drive not being set to SCSI ID 4.

RESOLUTION

To resolve this problem, please consult your DEC AlphaServer documentation or contact DEC.

Keywords          : ntgeneral nthowto ntsetup NTSrvWkst kbsetup
Version           : WinNT:3.51,4.0
Platform          : winnt

================================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 22, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.