Firmware Requirements for LexMark MarkVision MonitorLast reviewed: March 28, 1997Article ID: Q159911 |
The information in this article applies to:
SUMMARYLexmark MarkVision is a Windows program that provides printer configuration and status information, and gives you control over your Lexmark laser printers by using the bidirectional communication capability of the printer. MarkVision works with printers connected to your workstation through TCP/IP and DLC, and with printers on the Microsoft Network.
MORE INFORMATIONTo use MarkVision in a Windows NT environment, it is important to have the correct firmware revision to ensure proper results. Please refer to the table below for more information: The firmware mentioned is the minimum requirement.
Model Firmware Required Protocols Supported ----- ----------------- ------------------- MarkNet XL 15.62.01 LexLink, TCP/IP, NetWare Appletalk. MarkNet External XLe 03.51.01 Netware, Appletalk, and TCP/IP MarkNet (Small Card) 07.62.01 Lexlink , NetWare, and Appletalk MarkNet (Small Card) 09.62.01** Lexlink and TCP/IPUpdated firmware may be obtained at the following web site:
http://www.lexmark.com/service/service.htmlSelect the Drivers and Utilities option, and follow the instructions. The third-party contact information included in this article is provided to help you find the technical support you need. This contact information is subject to change without notice. Microsoft in no way guarantees the accuracy of this third party contact information. **NOTE: This device is only available by calling Lexmark TSC at (606) 232- 3000 The products included here are manufactured by vendors independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.
|
Additional query words: prodnt ibm optra 4039
© 1998 Microsoft Corporation. All rights reserved. Terms of Use. |