Setting the NIC Driver Startup Value to SYSTEM Causes STOP 0X1E

Last reviewed: September 9, 1997
Article ID: Q172353
The information in this article applies to:
  • Microsoft Windows NT Workstation version 4.0
  • Microsoft Windows NT Server version 4.0

SUMMARY

The startup value for a network adapter in Control Panel Devices should be set to AUTOMATIC. Setting the value to SYSTEM or BOOT may cause the system to trap with a STOP:0x0000001E upon system restart.

Behavior may vary from one network card to another.

MORE INFORMATION

You may use the LastKnownGood configuration to get into the system as this will use the configuration prior to the changed setting, or remove the network card from the system. This will cause the driver to fail to load and once back into the system, use the default startup value as configured with adapter installation.


Additional query words: 0x1E
Keywords : ntdriver NTSrvWkst kbenv
Version : WinNT:4.0
Platform : winnt


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 9, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.