Canon BJC-610 Printer May Not Print After Restarting Computer

Last reviewed: November 4, 1997
Article ID: Q174899
The information in this article applies to:
  • Microsoft Windows NT Workstation version 4.0
  • Microsoft Windows NT Server version 4.0

SYMPTOMS

If you use a Canon BJC-610 printer and install the updated printer driver for Cannon Bubble Jet series printers (Nt4bjc2.exe), you may experience one or more of the following symptoms:

  • You may be unable to print.
  • You are unable to print a test page or document after you restart the computer.
  • You are unable to print if you restart the computer and then attempt to print a test page from any program.
  • The printer may appear to be printing, but the print job does not print.
  • The printed output may be garbled.

RESOLUTION

To resolve this problem, use one or more of the following methods:

  • If the printer is connected to an enhanced capabilities port (ECP) or enhanced parallel port (EPP), enable bi-directional support for the port in the computer's CMOS.

    NOTE: Refer to the computer's documentation or manufacturer before you change the CMOS settings.

  • Do not turn the printer on until Windows NT is started. If the error light on the printer turns on, put the printer back on-line and then click Retry when you are prompted.
  • Remove the printer driver and then reinstall the original driver. For information about how to do so, please see the following article in the Microsoft Knowledge Base:

          ARTICLE-ID: Q135406
    
          TITLE     : Steps to Manually Remove and Reinstall a Printer Driver
    
    

STATUS

Microsoft is researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.

MORE INFORMATION

The printer driver installs normally and the printer appears to function properly until you restart the computer, and then print a test page or document.

For additional information, please see the following article in the Microsoft Knowledge Base:

   ARTICLE-ID: Q173007
   TITLE     : Updated Cannon Bubble Jet drivers for Windows NT 4.0

To print a test page in Windows NT, follow these steps:

  1. Click Start, point to settings, and then click Printers.

  2. Right-click the printer you are using, and then click Properties.

  3. On the General Tab, click Print Test Page.


Additional query words: prodnt 4.00
Keywords : kbprint
Version : WINNT:4.0
Platform : winnt
Hardware : x86


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 4, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.