System Hangs with Micronics Motherboard, Ultrastor U34F

Last reviewed: May 6, 1997
Article ID: Q99645
The information in this article applies to:
  • Microsoft Windows NT operating system version 3.1

SYMPTOMS

Your system may stop responding (hang) when you run Windows NT under the following configuration:

  • Ultrastor U34F local bus controller
  • Micronics 486 VESA local bus motherboard

Note: This problem does not occur on Micronics MX30 motherboards.

CAUSE

This problem is caused by a timing conflict between Windows NT, the Ultrastor controller, and the Micronics motherboard.

Note: The problem does not occur with ISA bus controllers from Ultrastor.

RESOLUTION

There are two ways to work around this problem. You can disable the external cache on your motherboard, or you can return your motherboard to Micronics for repair. Micronics is aware of this problem and has a fix available. The reference number for the Micronics fix is VLBA03. Micronics can be reached at (510) 651-2300.


Additional query words: prodnt
Keywords : kbhw nthw
Version : 3.1
Platform : WINDOWS


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: May 6, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.