WD95: Quiet Mode Setup Does Typical Instead of Complete SetupLast reviewed: February 6, 1998Article ID: Q139563 |
The information in this article applies to:
SYMPTOMSDuring Quiet Mode Setup, a Typical installation is performed instead of the expected Complete installation.
CAUSETypical is now the default installation type for all modes of Setup.
RESOLUTIONTo force Quiet Mode Setup to perform a Complete installation, use the appropriate command line below: To install from disk or disk images:
Setup /B4 /QTo install after Administrative Setup with the Workstation option:
Setup /B5 /Q MORE INFORMATIONThe /B switch corresponds to the buttons shown when you are prompted to choose the installation type. Typical is /B1, Compact is /B2, Custom is /B3, Workstation is /B4 (if you are running Quiet Mode Setup from disk images, this switch represents Complete Setup), and /B5 is Complete (if you already did an Administrative Setup).
|
KBCategory:
© 1998 Microsoft Corporation. All rights reserved. Terms of Use. |