Applies To
Report.
Description
You can use the CurrentX and CurrentY properties to specify the horizontal and vertical coordinates for the starting position of the next printing and drawing method on a report. For example, you can use these properties to determine where the center point of a circle is drawn on a report section.
Setting
The CurrentX property specifies a Single value used in a numeric expression to set the horizontal coordinate of the next printing drawing method.
The CurrentY property specifies a Single value used in a numeric expression to set the vertical coordinate of the next printing drawing method.
The coordinates are measured from the upper-left corner of the report section that contains the reference to the CurrentX or CurrentY property. The CurrentX property setting is 0 at the section's left edge, and the CurrentY property setting is 0 at its top edge.
You can set the CurrentX and CurrentY properties by using a macro or a Visual Basic event procedure specified by the OnPrint property setting of a report section.
Remarks
Use the ScaleMode property to define the unit of measure, such as points, pixels, characters, inches, millimeters, or centimeters, that the coordinates will be based on.
When you use the following graphics methods, the CurrentX and CurrentY property settings are changed as indicated.
Method
Sets CurrentX, CurrentY properties to
Circle
The center of the object.
Line
The end point of the line (the x2, y2 coordinates).
Print
The next print position.
See Also
Circle method, DrawMode property, DrawStyle property, Event properties, Left, Top properties, Line method, Print event, Print method, Scale method, ScaleHeight, ScaleWidth properties, ScaleLeft, ScaleTop properties, ScaleMode property.
Example
See the Print method example.