Checklist for PCI

If a recommended feature is implemented, it must meet the PC 98 requirements for that feature as defined in this document.

1. All components comply with PCI 2.1

Required

2. System does not contain ghost cards

Required

3. System uses standard method to close BAR windows on nonsubtractive decode PCI bridges

Required

4. System supports PCI docking through a bridge connector

Recommended

5. PCI chip sets support Ultra DMA/33

Required

6. System-board bus complies with PCI 2.1

Required

7. Bus master privileges are supported for all connectors

Required

8. ISA Write Data Port address is propagated to the ISA bus at power up

Required

9. Functions in a multifunction PCI device do not share writable PCI Configuration Space bits

Required

10. Devices use PCI 2.1 Configuration Space register for Plug and Play device ID

Required

11. Device IDs include PCI 2.1 Subsystem IDs

Required

12. Configuration Space is correctly populated

Required

13. Interrupt routing supported using ACPI

Required

14. BIOS does not configure I/O systems to share PCI interrupts

Recommended

15. BIOS configures boot device IRQ and writes to the interrupt line register

Required

16. Hot swapping for any PCI device uses ACPI-based methods

Required

17. All PCI components comply with PCI Bus Power Management Interface specification

Required