If a recommended feature is implemented, it must meet the PC 98 requirements for that feature as defined in this document.
1. Controller complies with ATA-2 specification
| Required |
2. Bootable IDE controller supports El Torito No Emulation mode
| Required |
3. System BIOS and option ROMs support Int 13h Extensions
| Required |
4. Controller and peripherals support media status notification
| Required |
5. Dual IDE adapters use single FIFO with asynchronous access or dual FIFOs and channels
| Required |
6. System BIOS and devices support LBA
| Required |
7. Controller and peripherals support PCI IDE bus mastering
| Required |
8. Controller and peripheral connections include Pin 1 cable designation with keyed and shrouded connectors
| Required |
9. Peripherals comply with SFF 8020i, Version 2.5 or higher
| Required |
10. BIOS enumeration of all ATAPI devices complies with SFF 8020i, Version 2.5 or higher
| Required |
11. Devices support ATAPI RESET command
| Recommended |
12. IDE/ATAPI controllers and devices support Ultra DMA/33
| Required |
13. Operating system recognizes the boot drive in a multiple-drive system
| Required |
14. Each device has a Plug and Play device ID
| Required |
15. Dynamic resource configuration supported for all devices
| Required |
16. Resource configuration meets bus requirements
| Required |
17. ISA address ranges 3F7h and 377h are not claimed by IDE controllers
| Required |
18. Device supports ATA STANDBY command
| Required |
19. Bus and device meet PC 98 power management requirements
| Required |