VoiceAnswer

Commands to send to the modem to answer a call in voice mode.

One or more command strings

HKR, VoiceAnswer,               1,, "at#cls=8"
HKR, VoiceAnswer,               2,, "at#vls=0"
HKR, VoiceAnswer,               3,, "at#vbt=1"
HKR, VoiceAnswer,               7,, "ata"

Usually, the following actions are performed in VoiceAnswer:

• Place the modem into voice mode.
• Set the DTMF tone generation duration.
• Make sure speakerphone is on hook.
• Set modem to connect immediately after dialing. However, if the modem cannot detect busy while in voice mode (or in speakerphone mode while in voice mode), the modem should not be set to connect immediately, so that the modem has a chance to report busy before it is connected.
• Answer the modem.