VoiceDialNumberSetup

Commands to place a call in voice mode.

One or more command strings can be used. For example,

HKR, VoiceDialNumberSetup,               1,, "at#cls=8"
HKR, VoiceDialNumberSetup,               2,, "at#vls=0"
HKR, VoiceDialNumberSetup,               3,, "at#vrn=0"
HKR, VoiceDialNumberSetup,               4,, "at#vbt=1"

Usually, the following actions are performed in VoiceDialNumberSetup:

• Place the modem into voice mode.
• Set the DTMF tone generation duration.
• Make sure speakerphone is on hook.
• Set modem to connect immediately after dialing. However, if the modem cannot detect busy while in voice mode (or in speakerphone mode while in voice mode), the modem should not be set to connect immediately, so that the modem has a chance to report busy before it is connected.