WODM_GETPITCH

See also WODM_SETPITCH

Sent to a waveform output device driver to request the current pitch rate setting for a device.

MMSYSERR_NOTENABLED

The driver failed to load or initialize.

MMSYSERR_NOTSUPPORTED

The driver does not support changes to the pitch rate.


DWORD dwParam1

Specifies a far pointer to a DWORD location. The driver fills this location with the current pitch rate setting. The rate is specified as a fixed-point value. The high-order word of the DWORD contains the signed integer part of the number, and the low-order word contains the fractional part. The fraction is expressed as a WORD in which a value of 0x8000 represents one half, and 0x4000 represents one quarter. For example, the value 0x00010000 specifies a multiplier of 1.0 (no pitch change), and a value of 0x000F8000 specifies a multiplier of 15.5.

DWORD dwParam2

Unused.

Drivers do not have to support pitch rate changes. However, if a driver supports changes to the pitch rate with the WODM_SETPITCH message, it must support queries with the WODM_GETPITCH message.