ACMDM_STREAM_UNPREPARE

See also ACMDM_STREAM_CLOSE, ACMDM_STREAM_CONVERT, ACMDM_STREAM_OPEN, ACMDM_STREAM_PREPARE, ACMDM_STREAM_RESET, ACMDM_STREAM_SIZE, ACMDRVOPENDESC, ACMDRVSTREAMHEADER, ACMDRVSTREAMINSTANCE, ACMDRVSTREAMSIZE

lParam1 = (LPARAM) pacmDSI  // see below
lParam2 = (LPARAM) pacmDSH  // see below

Sent to an Audio Compression Manager (ACM) driver to allow the driver to optionally unprepare an ACMDRVSTREAMHEADER structure and corresponding data blocks used for conversions. This message is usually sent to an ACM driver in response to an acmStreamUnprepareHeader call.

Return MMSYSERR_NOERROR if the operation is successful or an error value otherwise. The following errors are possible:

MMSYSERR_NOTENABLED	The driver failed to load or initialize.
MMSYSERR_NOTSUPPORTED	The driver does not support this message.

lParam1

Address of the ACMDRVSTREAMINSTANCE structure for the conversion stream that the prepare request is for.

lParam2

Address of the ACMDRVSTREAMHEADER structure identifying the source and destination data blocks that should be unprepared.

An ACM driver must support the ACMDM_STREAM_UNPREPARE message if it supports the ACMDM_STREAM_PREPARE message.

The default response for the ACMDM_STREAM_UNPREPARE message is to return MMSYSERR_NOTSUPPORTED. In this case, the ACM will mark the stream header as being unprepared (clears the ACMSTREAMHEADER_STATUSF_PREPARED flag in the fdwStatus member of the ACMDRVSTREAMHEADER structure).

If a driver requires other cleanup operations to unprepare the header and data blocks used for conversions, it should perform these operations and return MMSYSERR_NOERROR. The ACM will then mark the stream header as being unprepared (a driver should never modify the ACMSTREAMHEADER_STATUSF_PREPARED flag in the fdwStatus member of the ACMDRVSTREAMHEADER structure).

The ACM will always send the ACMDM_STREAM_PREPARE and ACMDM_STREAM_UNPREPARE messages to a driver even if the driver returns MMSYSERR_NOTSUPPORTED. This allows a driver to optionally perform minor preparations for the header and data buffers while still taking advantage of the default behavior performed by the ACM

Note that the following parameters for the ACMDM_STREAM_UNPREPARE message will be validated before calling the driver:

The lParam1 parameter will contain a valid pointer to an ACMDRVSTREAMINSTANCE structure with the same information as the corresponding ACMDM_STREAM_OPEN message.
The lParam2 parameter will contain a valid pointer to an ACMDRVSTREAMHEADER structure with the proper members initialized for the unprepare request. This structure will be at least the size of the base ACMDRVSTREAMHEADER structure.
The cbStruct member of the ACMDRVSTREAMHEADER structure will be set to at least the size, in bytes, of the base ACMDRVSTREAMHEADER structure.
The remaining members of the ACMDRVSTREAMHEADER structure will be within the bounds described in the documentation for the ACMDRVSTREAMHEADER structure.

The driver does not need to check for these conditions.