III.    Notes

1. If CPNAME is not configured in VTAM, then leave both Local Control Point Name and Network Name blank. These two parameters work together; if either parameter is supplied, the other should also be supplied.

2. For Dependent LU6.2, LOCADDR must be greater than 0 and the PSERVIC value in the Mode definition will be X'060200000000000000002C00'.

3. For Channel, IDBLK, IDNUM will not be used.

4. The USSTAB parameter should not be defined for an LU6.2 LU. If 3270 LUs are defined on the same PU, the USSTAB parameter should be coded on them individually to avoid coding it on the PU statement.