III.    Notes

1. If CPNAME is not configured in VTAM, then leave both Local Control Point Name and Network Name blank. These two parameters work together; if either parameter is supplied, the other should also be supplied.

2. For Independent LU6.2, LOCADDR must be 00, the PSERVIC should be X'060200000000000000002F00', and the SNASVCMG mode should exist in the mode table.

3. For PVC, IDNUM and IDBLK will not be used.

4. You may have to consult with your X.25 provider for X.25 link service parameters.

5. The 11th byte in the PSERVIC value must be '2C' for Dependent LU6.2.

6. The USSTAB parameter should not be defined for an LU6.2 LU. If 3270 LUs are defined on the same PU, the USSTAB parameter should be coded on them individually to avoid coding it on the PU statement.