IExchangeExportChanges::GetLastError
The GetLastError method retrieves information about the most recent error during importing the incremental message changes.
HRESULT GetLastError(
HRESULT hResult,
ULONG ulFlags,
LPMAPIERROR FAR * lppMAPIError
);
Parameters
- hResult
- Input parameter. An error returned by one of the other IExchangeImportContentsChanges methods.
- ulFlags
- Input parameter. Defined flag that controls the format of the error report:
- SYNC_UNICODE
- Specifies that text is Unicode. If this flag is not set, the text is returned as the type of text in the clients' code page.
- lppMAPIError
- Output parameter. Points to the address of a MAPI MAPIERROR structure, which contains information on the last error.
Return Values
See Return Values.
In addition, GetLastError can return one of the following values:
- SUCCESS_SUCCESS
- The method completed successfully.
- SYNC_E_INVALID_PARAMETER
- One of the parameters was not valid.
- MAPI_E_NOT_ENOUGH_MEMORY
- There wasn't enough memory to complete the operation.
See Also
IExchangeExportChanges