Connection Fails on SNA Server with Two Token Ring NICs

ID: Q129601


The information in this article applies to:
  • Microsoft Windows NT Advanced Server, version 3.1
  • Microsoft Windows NT Server version 3.5
  • Microsoft SNA Server, versions 2.0, 2.1
    on the following platforms: NT


SYMPTOMS

If an SNA Server has two token ring network interface cards (NIC) and multiple SNA Server link services and connections (PU's) defined over each NIC, one or more SNA Server connections may fail to activate when the connections are started, if the remote system is located across a source routing bridge.

When an SNA Server connection is activated, SNA Server sends a TEST frame to the remote address, specifying the local network first. If no response is received, the TEST frame is resent with the "all routes" bit set. However, when this problem occurs, the second TEST frame (specifying the source routing bit) is never sent for a given connection.


CAUSE

This problem occurs when the Windows NT DLC protocol does not handle multiple token ring NICs properly.


STATUS

Microsoft has confirmed this to be a problem in Windows NT version 3.5. A fix to this problem is in development, but has not been regression-tested and may be destabilizing in production environments. Microsoft does not recommend implementing this fix at this time. Contact Microsoft Product Support Services for more information on the availability of this fix.


RESOLUTION

To correct this problem in Windows NT Server version 3.5, apply the fix.

To correct this problem in Windows NT Advanced Server version 3.1, upgrade to Windows NT Server version 3.5 and apply the fix.

Additional query words: prodnt 3.10 2.00 2.10 dlc sna prodsna

Keywords :
Version : :3.1; WINDOWS:2.0,2.1; winnt:3.5
Platform : WINDOWS winnt
Issue type :


Last Reviewed: November 18, 1999
© 2000 Microsoft Corporation. All rights reserved. Terms of Use.