SNA Server Support for FNA and HNA

ID: Q139115


The information in this article applies to:
  • Microsoft SNA Server, versions 2.11, 3.0, 4.0


SUMMARY

SNA Server version 2.11 supports the "Fujitsu Network Architecture" (FNA) and "Hitachi Network Architecture" (HNA) variants to IBM SNA. Support for these alternate SNA protocols is enabled adding the following registry keys:


   HKEY_LOCAL_MACHINE/SYSTEM/CurrentControlSet/Services/SnaServr/Parameters

      FNA_SUPPORT: REG_SZ: <value>   (to enable FNA) 
-or-

      HNA_SUPPORT: REG_SZ: <value>   (to enable HNA) 
where <value> can be set to anything. The presence of this registry key enables this support.


MORE INFORMATION

If SNA Server is communicating to a host system which is running Fujitsu Network Architecture (FNA) protocol, the following sense code errors may occur if FNA_SUPPORT is not enabled:

80050001: No session: SNA Server received a request other than
session control request when no LU-LU session was active
If SNA Server is communicating to a host system which is running Hitachi Network Architecture (HNA) protocol and HNA_SUPPORT is not enabled, an out- of-chain CANCEL message sent to a type 3 Printer LU will be rejected by SNA Server rather than being sent to the printer application.

Additional query words: prodsna

Keywords : kbenv kbnetwork ntnetserv sna211 sna3 sna4
Version : WINDOWS:2.11,3.0,4.0
Platform : WINDOWS
Issue type :


Last Reviewed: October 5, 1999
© 2000 Microsoft Corporation. All rights reserved. Terms of Use.