Configure Multiple SNA Servers to Use Single Distributed Link

ID: Q155541


The information in this article applies to:
  • Microsoft SNA Server, versions 2.11 SP1, 3.0
    on the following platforms: NT


SUMMARY

The distributed link service is a feature added in Service Pack 1 for Microsoft SNA Server version 2.11 that allows SNA Servers to be deployed in a new distributed model, which combines the benefits of the branch and central models of deployment. For details on the distributed model and link service, please see the SNA Open Gateway Architecture (SOGA) document.

Information on SOGA can be found in the following locations:

http://www.microsoft.com/presspass/press/1995/95dec/sogapr.htm
http://www.microsoft.com/sna/soga.htm


MORE INFORMATION

The original SOGA document indicated that a distributed link service could not be used by multiple SNA Servers simultaneously. The intent of this was to prevent you from trying to configure a distributed link service on the local SNA Server for a local connection. A distributed link service can only be used by remote SNA Servers. However, it is possible to have multiple remote systems using a single distributed link service.

To do this, each remote system must be assigned a unique Service Access Point (SAP). SNA SAPs must be a hexadecimal multiple of four and must be defined on both ends of the connection. Assuming you had three remote systems you intended to use the distributed link service, you would use SAPs '04', '08', and '0C'.

The SAPs are defined in the communications line description on the AS/400. Your AS/400 administrator can help you with this. Using the example of three systems, you would add '08' and '0C' to the SAPs already defined on the line. SAP '04' is defined by default.

Additional query words: sna prodsna

Keywords : kbnetwork ntnetserv snadls
Version : WINDOWS:2.11 SP1,3.0
Platform : WINDOWS
Issue type :


Last Reviewed: September 21, 1999
© 2000 Microsoft Corporation. All rights reserved. Terms of Use.