The information in this article applies to:
SYMPTOMSWhen you are setting the port numbers for AS/400 definitions, if multiple ports are used and one is left at Use Default, all ports will connect to the AS/400 with the definition set to Use Default. This port setting is found in the TN5250 AS/400 Definition on the Terminal Types property page in SNA Server Manager. For example, set up two AS/400 definitions with definition A set to use port 24 and definition B set to Use Default in the port setting. When a TN5250 client initiates a session, it will go to AS/400 definition B with the Use Default port setting, even if assigned to AS/400 definition A. CAUSEWhen determining which AS/400 definition the TN5250 client was assigned to, a check by TN5250.EXE finds a default port entered in an AS/400 definition and erroneously assigns all clients to the default setting. RESOLUTIONTN5250.EXE has been modified to assign the proper AS/400 definition to the client requesting a session when a "Use Default" port setting exists in any TN5250 AS/400 definition. STATUSMicrosoft has confirmed this to be a problem in SNA Server versions 3.0 and 3.0 Service Pack 1 (SP1). This problem was corrected in the latest SNA Server version 3.0 U.S. Service Pack. For information on obtaining this Service Pack, query on the following word in the Microsoft Knowledge Base (without the spaces): S E R V P A C K Additional query words:
Keywords : kbnetwork snamanager snatn5250 kbfix3.00.sp2 |
Last Reviewed: November 24, 1999 © 2000 Microsoft Corporation. All rights reserved. Terms of Use. |