Attachmate Advanced ISCA Adapter General Information

ID: Q222025

The information in this article applies to:

Microsoft SNA Server, versions 2.11SP1, 2.11SP2, 3.0, 3.0SP1, 3.0SP2, 3.0SP3, 4.0, 4.0SP1, 4.0SP2

SUMMARY

This article outlines configuration and use of the Attachmate Advanced ISCA PNP (Plug and Play) and Advanced ISCA PCI SDLC Adapters.

The Advanced ISCA Plug and Play ISA Adapter

The Advanced ISCA Plug and Play Adapter is an ISA Plug and Play adapter. It may be configured in Legacy mode, meaning it will not participate in Plug and Play enumeration, and can be "hard coded" with IRQ, I/O, and memory range, or it can be configured in Plug and Play mode in which the resources are assigned by the Plug and Play BIOS extensions.

Plug and Play mode may require the use of the PNPISA driver in Windows NT 4.0. The configuration is accomplished by either an MS-DOS-based or a Windows NT-based diagnostic program. The MS-DOS diagnostic is Iscapnp.exe and the Windows NT diagnostic is AdvIscaDiagNT. The Windows NT diagnostic is installed using the supplied Setup program. The link service is installed into SNA Server in the same manner, using a Setup program. If the adapter is in Legacy mode, you should install the link service by selecting External Link Service on the Tools menu. If in Plug and Play mode, on the Insert menu, select Link Service.

The driver is Adisync.sys coupled with Ibmsdlc.dll providing the link layer, and is designed to support up to three adapters in a server. The link service is ADISDLC#.

The Advanced ISCA PCI Adapter

The Advanced ISCA PCI Adapter is a PCI version 2.1 compliant adapter. Its resources are assigned by the BIOS and, depending upon the BIOS and PCI chipset in use, may be changed through the BIOS or diagnostics. The diagnostic is IscaDiagNT and is Windows NT-based. It is installed by running Setup from the installation disk set or the downloaded file. The link service is also installed using a Setup routine and is reported in Add/Remove Programs in Control Panel. It is also removed using Add/Remove Programs.

The diagnostic will report a "board not found" message if the SNA Server link service using the adapter is active. The link service will also not become active if the diagnostic is active.

The driver is Adpsync.sys coupled with Ibmsdlc.dll, and is designed to support up to three adapters. The link service is ADPSDLC#.

Both adapters use a special 26-pin cable, which is an RS-232 alternate. The additional pin is used for digital versus analog circuit detection. They are rated at 512 KB by Attachmate.

REFERENCES

Attachmate Technical Bulletins 167, 173. PCI specification

Additional query words:

Keywords :
Version : WINDOWS:2.11SP1,2.11SP2,3.0,3.0SP1,3.0SP2,3.0SP3,4.0,4.0SP1,4.0SP2
Platform : WINDOWS
Issue type : kbinfo