"Invalid Keyword" with Windows for Workgroups, TCP/IP
ID: Q100652
|
SUMMARY
After installing TCP/IP protocol from the Microsoft Windows for
Workgroups Connectivity Diskette, you may receive the following error
messages:
NET0101: Value for keyword not found in PROTOCOL.INI or TCPUTILS.INI
file by TCP
Unloadable TCP 1.0 not loaded.
NET0116: TCP access failure by Tiny RFC
Tiny RFC 1.0 not loaded
The errors occur because the TCP/IP addresses have not been
established in the PROTOCOL.INI. The installation program does not
force entry of the addresses.
The PROTOCOL.INI will look like the following:
[TCPIP]
DriverName=TCPIP$
NBSessions=6
NetFiles=C:\WFW31
tcpsegmentsize=1450
tcpwindowsize=1450
BINDINGS=MS$DECGEN
LANABASE=1
It needs to look like the following:
[TCPIP]
DriverName=TCPIP$
NBSessions=6
NetFiles=C:\WFW31
tcpsegmentsize=1450
tcpwindowsize=1450
BINDINGS=MS$DECGEN
LANABASE=1
IPAddress0= (Valid IP Address)
SubNetMask0= (Valid Sub Net Mask)
DefaultGateway0= (Optional)
To have Windows Control Panel make the correction to the PROTOCOL.INI
do the following:
Steps to add TCP/IP Addresses
- Within Windows for Workgroups Version 3.10 select Control Panel.
- Within Control Panel select Network.
- Within Network select Adapters.
- Select Protocols.
- Highlight TCP/IP.
- Select Settings
- Within the Advanced Protocol settings :
Highlight Default Gateway enter values and select SET (Optional)
Highlight IP Address enter values and select SET
Highlight Subnet Mask enter values and select SET
- Exit and Restart Windows for Workgroups
Reference:
"Integrating Microsoft Windows for Workgroups with Microsoft LAN
Manager 2.2"
Additional query words:
wfw wfwg 2.20
Keywords :
Version :
Platform :
Issue type :