FIX: F6415 on OPEN Statement w/ MS-DOS APPEND Command

ID: Q79713


The information in this article applies to:
  • Microsoft FORTRAN for MS-DOS, versions 4.01, 5.0, 5.1


SYMPTOMS

Programs compiled with Microsoft FORTRAN version 4.1, 5.0, or 5.1, that attempt to open a file that exists in any of the directories specified with the MS-DOS APPEND command, may generate the following error:

run-time Error F6415: OPEN(filename)
- File Already Exists
This error may still be generated even if the full path to the filename is given. Microsoft FORTRAN versions earlier than 4.1 do not recognize directories specified using the APPEND command, and do not generate this error message.


RESOLUTION

Disabling the MS-DOS APPEND command removes this error message. Opening the file with STATUS='OLD' also prevents this error message.


STATUS

Microsoft has confirmed this to be a problem in Microsoft FORTRAN versions 4.1, 5.0, and 5.1 for MS-DOS. This problem was corrected in the Microsoft FORTRAN PowerSttion products.


MORE INFORMATION

The following code generates the F6415 error message if the file TEST.DAT exists in a directory specified by the DOS APPEND path.

Sample Code #1


      OPEN (1, FILE='Test.DAT')
      END 
A possible solution to this problem is shown below:

Sample Code #2


      OPEN (1, FILE='Test.DAT', STATUS='OLD')
      END 

Additional query words: 4.10 5.00 5.10

Keywords : kberrmsg kbFortranPS kbLangFortran
Version : :4.01,5.0,5.1
Platform : MS-DOS
Issue type :


Last Reviewed: November 1, 1999
© 2000 Microsoft Corporation. All rights reserved. Terms of Use.