Error Running Setup to Install LAN Manager: 3 Causes

ID: Q99236


The information in this article applies to:
  • Microsoft LAN Manager, version 2.2


SYMPTOMS

After you install Microsoft OS/2 1.3 on a Microsoft LAN Manager 2.2 server you are prompted to reboot the computer. When it starts again a prompt asks if you want to continue with the LAN Manager installation; if you choose NO then later decide to install LAN Manager, you must run Setup from the OS/2 setup diskette. Doing this, you may encounter a message stating that "an error was encountered while determining file type HPFS or FAT of your active disk drive." If you do, the computer hangs before you get to the LAN Manager Setup screen.


CAUSE

This error message may be issued for several reasons, three of which are not obvious and often are not considered when troubleshooting:

  • There may be a hole in your SCSI drive chain where you have removed or installed a disk drive lately.


  • The SCSI drive chain may not be terminated properly per manufacturer specifications.


  • The computer's CMOS settings may not be correct.



RESOLUTION

Check the SCSI drive train for evidences of the first two conditions.

For possible CMOS problems there are several things to check. Floppy drives must be set for the right types (1.44 MB, 1.2 MB, 720K, or 360K). Also check to see that memory settings are correct for your computer's memory. It also is advisable to check the sections in CMOS that do not seem relevant to the problem, because bad CMOS settings are known to to cause peculiar problems.

These are quick and easy checks to make before you look into other areas.

Additional query words: 2.20 2.2 install

Keywords : kbnetwork
Version : :2.2
Platform :
Issue type :


Last Reviewed: November 9, 1999
© 2000 Microsoft Corporation. All rights reserved. Terms of Use.