XFOR: Uninstall SMTP Gateway and Install IMC to Route SMTP Mail

ID: Q197977

The information in this article applies to:
  • Microsoft Exchange Server, version 4.0

SUMMARY

This article explains how to remove the SMTP Gateway for MS Mail postoffice and install the Exchange Server Internet Mail Connector to route the SMTP mail for the downstream post offices.


MORE INFORMATION

To remove the SMTP Gateway, install and configure the Exchange Server Internet Mail Connector, perform the following steps:

  1. Uninstall the access component.


  2. Uninstall the gateway component.


  3. Configure the Internet Mail Connector for Exchange Server.


  4. Install the access component on the downstream post office and point it to the Exchange shadow post office.


To set up the old SMTP gateway to communicate with Exchange Server, perform the following steps:

  1. Install -r from the SMTP Gateway access disk.


  2. Install -r from the SMTP Gateway disk.


  3. Install Gateway access disk point to the shadow post office. No downstream post offices need to be changed.


To configure the Internet Mail Connector as the SMTP gateway for MS Mail users, perform the following steps:

  1. Smarthost must route to IP address of the Exchange Server computer.


  2. Uninstall the access component from hub post office.


  3. Uninstall the gateway component from hub post office.


  4. Re-install the access component on the hub post office pointing to the connector post office as the gateway post office.


Because the Internet Mail Connector is already up an running on the Exchange Server computer(they must test outgoing mail), they should now be set to send and receive through the Internet Mail Connector.

Keywords :
Version : WinNT:4.0
Platform : winnt
Issue type : kbhowto


Last Reviewed: April 20, 1999
© 2000 Microsoft Corporation. All rights reserved. Terms of Use.