PRB: Syntax Error When Convert 2.x Screen That Has a Spinner

ID: Q140223

3.00 WINDOWS kbtool kbprb

The information in this article applies to:

• Microsoft Visual FoxPro for Windows, version 3.0

SYMPTOMS

When you convert a screen from a earlier version of FoxPro to Visual FoxPro and that screen has a spinner on it, the screen will finish converting and then display "Syntax error" if the SET POINT command is set to a comma in Visual FoxPro.

When the error is displayed, you might think that the screen did not finish converting. However, the screen has indeed finished converting; it just cannot be run, even if you set the SET POINT command back to the default of a period.

CAUSE

When the SET POINT TO command is set to a comma, it places a comma in the Increment and Value properties line in the Properties field of the .scx file. Visual FoxPro requires a period in that field and changes it to a comma in the spinner when the form is run.

RESOLUTION

Set the SET POINT TO command to a period before converting the form, and then set it back to a comma after the conversion takes place.

To correct a converted form that has the problem, you must open the form as a table and modify the properties memo field of the spinner. The Increment and Value properties will have a comma in the numeric number that is assigned to them. Replace the comma with a period and the form can be modified or run.

STATUS

This behavior is by design.

MORE INFORMATION

Steps to Reproduce Behavior

1. Create a screen called Spinner in an earlier version of FoxPro.

2. Add a spinner to the screen, and then close it.

3. Open Visual FoxPro and type the following command in the Command window:

   SET POINT TO ","

   Visual FoxPro. When asked what format to convert the screen, choose
   Functional. The problem is the same if converting in Functional or
   Visual format. As the screen is finishing the conversion, the error
   "Syntax Error" appears. Trying to run or modify the converted form
   gives the same error.

   USE spinner.scx

   record that has the word "spinner" in it. After finding that record,
   open the Properties memo field of that record, and locate the properties
   Increment and Value. Note that the number beside these properties may
   have a comma in it. Replace the comma with a period, and close the memo
   field. After closing the table, you should be able to run or modify the
   converted form. The SET POINT TO "," command can then be used to show
   the spinner using commas.

Keywords          : FxtoolConverter 
Version           : 3.00
Platform          : WINDOWS